Tutorial - Glass Tile Pendant

This tutorial will show you how to make glass tile pendants (as above).

Materials required:

Glass tile (7/8" x 7/8")

Paper (scrapbook paper, scraps, photo)

Dimensional glaze (Diamond Glaze, Glossy Accents)

Bail

Square cutting template (made from card)

Pencil

Glue (to fix bail)

Scissors

Paintbrush

Step 1 - Choose your pattern paper. I have chosen Japanese pattern paper in the pendants above, but you can use your scraps of paper or even print a photo for a personalised pendant (great for mothers day, fathers day, birthdays etc).

Japanese Paper

Step 2 - Make your square cutting template by measuring a 7/8" square from card (I recycled a food cardboard box), cut out the square using a craft knife. This will be used as a 'viewfinder' over your patterned paper. Move the viewfinder over the paper and select an appropriate section that makes a pretty frame. Try to select near the edge so as not to waste paper :

Square Cutting Template (Viewfinder)

Step 3 - Draw a square on to the paper, cut the paper square out and snip small rounded corners (because the glass has rounded corners, your paper will need to match):

Step 4 - Apply a generous layer of glaze to the back of the glass tile (the flatest part of your tile). Make sure to coat all the surface and slightly over the rounded edges. Place your piece of paper over the glass tile (remember to place the paper face down on to the glass), move the paper into place with your fingers and turn the tile over. Push down firmly on the tile to rid of any air bubbles that may have occurred. Leave to dry. Your tile may slide over the paper slightly, if so, move it back into place. TIP - use a grip seal bag as a base, this will prevent a sticky mess on your work surface:

Step 5 - Once dry, apply another generous amount of glaze on top of the paper. Spread the glaze over the paper, paying particular attention to the corners and edges. TIP - lightly glide your brush over the paper to minimise brushstroke marks in the glaze. Let to dry and set. Once dry, the texture is very smooth and shiny, like glass.

Step 6 - Apply glue (suitable for metal) to the back of the pendant and apply your bail. Let to dry/set.

I used E6000 glue for attaching the bail - this is an industrial glue I use for my glasswork. There are a couple of options for bails. You can use a flat bail (right in the photo) or an Aanraku jewellery bail (left in the photo). If using the flat bail, you will need to attach a jump ring to hang from a chain, the Aanraku bail already has a loop for a chain.

Two different bails (above)

(two bails - front view)

You can create all sorts of pendants - here are some examples:

You can even add a touch of your own artwork or personalise by drawing on the prints. You can see from the pendants below that I have added the word Diva in bright pink. I used a Sakura glaze pen for this as these are very bright and do not run when the glaze is added:
I hope you enjoyed this tutorial.

Kathryn, Lazy Daisy xx